Filter
Top Products
3
WARNINGS
US
NOTE:
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this
equipment.
FCC Radiation Exposure Statement
This transmitter complies with FCC radiation exposure limit set forth
for an uncontrolled environment. To comply with the FCC RF
exposure compliance requirements, no change to the antenna or the
device is permitted. Any changes to the antenna or the device could
result in the device exceeding the RF exposure requirements and void
user authorization to operate the equipment. In addition, this
transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
This Class B digital apparatus complies with Canadian ICES-003. The
term "IC" before the equipment certification number only signifies that
the Industry Canada technical specifications were met.
Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation
of the device.
IC Radiation Exposure Statement
This transmitter complies with IC radiation exposure limit set forth for
an uncontrolled environment. To comply with the IC RF exposure
compliance requirements, no change to the antenna or the device is
permitted. Any changes to the antenna or the device could result in the
device exceeding the RF exposure requirements and void user
authorization to operate the equipment. In addition, this transmitter
must not be co-located or operating in conjunction with any other
antenna or transmitter.
For customers in Canada