Filter
Top Products
18
Miscellaneous
E
No signal off
When set to “Enable” the TV will automatically enter the
standby mode if there is no signal input for 6 minutes.
Menu operations
TV menu ->Setup
Time and date
Miscellaneous Channels Child lock
On-screen displays
No signal off Enable Disable
Geometry menu
You can set the geometry values of the picture such as
picture position and phase relation. The adjustments
are stored independently for each input mode.
Picture
TV menu
Picture horizontal
Picture vertical
Phase position
0
0
0
Geometry
Picture horizontal
Sets the horizontal picture position by moving the
picture left and right.
Picture vertical
Sets the vertical picture position by moving the picture
up and down.
Phase position
Adjusting the phase relation ensures a picture without
fl icker and noise. (Available only for RGB signal)
PC only
NOTE
• When a TV programme fi nishes, this function may not
operate.
• This function is not available in DTV mode.
E
On-screen displays
Here you can determine which on-screen displays are
to be shown by pressing
p
on the remote control.
E
Time and date
When you receive teletext, the correct date and time
setting is picked up automatically by the set.
If you do not receive teletext, you should set the “Date”
and “Time” manually. Also you have additional items
you can adjust as outlined below.
NOTE
• Time and date information confi gured manually cannot be
overridden automatically by the set.
• If the power to the set is cut off (disconnection of AC
cord, power outage, etc.), the auto time acquisition mode
through teletext reactivates.
Items
On-screen display
time
Sound mode
Time
Description
Sets the duration of the TV status and station
name display.
• This setting also affects other TV screens.
(Volume, Surround, etc.)
Sound mode display on/off (“yes”/“no”)
Time information display on/off (“yes”/“no”)
Items
Time
Date
Beginning of
daylight-saving
time
End of daylight-
saving time
Description
If you receive a station with teletext after
switching on your TV set, the time and date are
automatically registered. In the case of some
stations, the date may have to be entered
manually. For stations without teletext, enter the
time (00:00 to 23:59) and the date (day.month.
year) using the numeric buttons on the remote
control.
See the above item “Time”.
Enter the date for the beginning of daylight-
saving time if it deviates from the date
calculated automatically.
Enter the date of the end of daylight-saving
time if it deviates from the date calculated
automatically.
LC-42XD1E_gb_b.indd 18LC-42XD1E_gb_b.indd 18 2006/10/27 10:22:082006/10/27 10:22:08