Filter
Top Products
39
Loosen the 2 screws which secure the V.R.
Plate to move the V.R. Plate.
Move the V.R. Plate to disengage ADJUST
GEAR mesh and move the V.R. shaft and
ensure that when force is not exerted on the
pedal, the cut face of the Volume Shaft faces in
the direction shown.
Have the gears meshed and tighten the 2
screws. At this time, tighten gear backlash.
Carefully move pedal fully within the movable
range and check if the Volume range is
exceeded.
After finishing adjustments, be sure to perform
Volume Setting in Test Mode.
1
2
3
4
5
Take out the 2 screws which secure the Volume
Plate to remove the Volume Plate.
Remove the Volume Gear from the V.R. to
replace the V.R.
After the replacement, perform Volume Setting
in the Test Mode.
1
2
3
V.R. ADJUSTMENT
V.R. REPLACEMENT
SCREW (2) M4x8,
w/flat and spring washers
V.R. SHAFT
V.R. PLATE
ADJUST GEAR