Filter
Top Products
32
1
2
VOLUME ADJUSTMENT
Loosen the 2 screws which secure the VR
bracket to move the VR Bracket.
Move the VR Bracket to disengage the
gear mesh.
By adjusting gear mesh, fasten the 2
screws which secure VR Bracket.
Move the Brake Lever fully to the movable
range and check if the Volume Shaft’s
revolvable range is exceeded.
After adjustment, be sure to perform the
Volume setting in the Test Mode.
3
4
5
1
2
VOLUME ADJUSTMENT
Replace the Volume if it is malfunctioning.
Install the Volume in the manner so that 20+/-5
is indicated when force is not exerted.
Remove the 2 screws which secure the VR
Bracket.
Remove the Volume Gear from the Volume
Shaft and remove the Volume from the VR
Bracket to replace the volume.
After the replacement, be sure to perform the
Volume setting in the Test Mode.
3
In the test mode, if the Front Brake Volume’s Value movements are irregular, adjust or replace the Volume by
using the following procedure:
Take out the 4 screws and remove the VR cover.
The Front Brake Volume is inside the VR cover.
8 - 2 ADJUSTING/REPLACING THE ACCELERATOR VOLUME
TRUSS SCREW (4)
M4x8
ACCELERATOR GRIP
VR COVER
SCREW (1)
M4x8
VOLUME
ACCELERATOR VR BRACKET