Filter
Top Products
38
Using MIDI
General MIDI mode on/off and selecting
a MIDI channel.
Follow these steps to change MIDI pa-
rameters.
1. Repeatedly press
TRANSPOSE/
TUNE/MIDI
until
oFFGMMode
appears.
2. Within 5 seconds, repeatedly press
or to select the parameter you
want to change.
GM Mode
on/off (Default: Off): set to
on
when you want to have the key-
board receive GM data from another
MIDI device. Turning GM mode on
automatically turns
CHORD
off,
since GM mode and MIDI In Chord
Judge cannot be used at the same
time.
Set to
oFF
to turn GM mode off.
The tone, volume and other param-
eter settings of each channel are ini-
tialized. When playing received
MIDI data, bass tones are lowered
one octave and the piccolo tone is
raised one octave.
Keybd Ch
(Keyboard Basic Chan-
nel) (Default: 01): sets the channel
for sending MIDI data to an external
device.
Chord
(MIDI In Chord Judge)
(Default: Off): when set to on, the
keyboard determines basic channel
note data as auto accompaniment
chords per the current chord finger-
ing method. Turning GM mode on
automatically turns
Chord
off,
since GM mode and MIDI In Chord
Judge cannot be used at the same
time.
Local
(Local Control) (Default:
On): set to on to send data simulta-
neously to the keyboard’s speakers
and as MIDI data. Set to
oFF
to
send data only as MIDI data (the
speakers on the keyboard remain
silent).
AcompOut
(Accompaniment Out)
(Default: Off): set to on to send auto
accompaniment as MIDI data. Set to
oFF
to turn it off.
3. Within 5 seconds, use
+
or
–
to
change the setting of the parameter.
DUMPING/IMPORTING
DATA
The keyboard’s internal data, including
data recorded to memory and synthesiz-
er data, can be sent and received in bulk
as MIDI exclusive data through the MIDI
terminals. Thus, you can use a comput-
er or other MIDI device as an external
storage device.
First make connections from the
MIDI IN
and
MIDI OUT
terminals to an external
device using MIDI cables.
Note:
Some software does not support
MIDI exclusive data.
Dumping Data
1. Put the other device in its receive
standby mode.
See the owner’s manual that comes
with the receiving device for details.
2. Repeatedly press
TRANSPOSE/
TUNE/MIDI
until
BulkSnd?
ap-
pears.
3. Within 5 seconds, press to start
data send.
Sending
appears. The