Filter
Top Products
1-2SectionSystem Configurations
9
1-2-5 One-to-one Computer Connections
Use one of the connecting cables shown in the following diagram to connect a
personal computer with Support Software to the CPM2B for a 1:1 Host Link com-
munications or no-protocol (serial) communications.
RS-232C port
(D-sub 9-pin)
CPM2B CPU Board
Connecting Cable
XW2Z-200S-V (2 m)
XW2Z-500S-V (5 m)
IBM PC/AT or
compatible computer
RS-232C Port Connection
Peripheral port
CPM2B CPU Board
Connecting Cable
XW2Z-200S-V (2 m)
XW2Z-500S-V (5 m)
IBM PC/AT or
compatible computer
Peripheral Port Connection
CS1W-CN114
(0.05 m)
CQM1-CIF02
(3.3 m)
CPM1-CIF01
RS-232C Adapter
Note 1. The CQM1-CIF11 Connecting Cable cannot be used. (If one is connected,
the CPM2C will not recognize it; the PC will enter RUN mode at startup if
Communications Switch SW201 is ON and DM 6600 of the PC Setup is set
to its default setting so that the Programming Console’s mode switch con-
trols the startup mode.)
2. Refer to Appendix A Standard Models for details on the Support Software
that can be used with the CPM2B.