Filter
Top Products
183
Appendix C
Programming Console Operations
Name Function Page
Data Clear Used to erase data, either selectively or totally, from the Program Memory and
the IR, AR, HR, DM, and TC areas.
47
Address Designation Displays the specified address. 50
Program Search Searches a program for the specified data address or instruction. 55
Instruction Insert
Instruction Delete
Allows a new instruction to be inserted before the displayed instruction, or
deletes the displayed instruction (respectively).
57
Program Check Checks the completed program for syntax errors (up to three levels in H-type
PCs).
53
Error Message Read Displays error messages in sequence, starting with the most severe messages. 148
Bit/Word Monitor Displays the specified address whose operand is to be monitored. In RUN or
MONTR mode it will show the status of the operand for any bit or word in any
data area.
150
Forced Set/Reset Set: Used to turn ON bits or timers, or to increment counters currently
displayed on the left of the screen.
Reset: Used to turn OFF bits, or to reset timers or counters.
153
Hex/BCD Data Change Used to change the value of the leftmost BCD or hexadecimal word displayed
during a Bit/Word Monitor operation.
155
SV Change
SV Reset
Alters the SV of a timer or counter either by incrementing or decrementing the
value, or by overwriting the original value with a new one.
156
Program Memory Save Saves Program Memory to tape. 158
Program Memory Restore Reads Program Memory from tape. 159
Program Memory Compare Compares Program Memory data on tape with that in the Program Memory
area.
159
System Operations
Operation/Description Modes* Key sequence
Data Clear
Unless otherwise specified, this
operation will clear all erasable
memory in Program Memory and
IR, HR, AR, DM, and TC areas. To
clear EPROM memory the write
enable switch must be ON (i.e.,
enabled). The branch lines shown
are used only when performing a
partial memory clear, with each of
the memory areas entered being
retained. Specifying an address will
result in the Program Memory after
and including that address being
deleted. All memory up to that
address will be retained.
P
CLR
PLAY
SET
NOT
REC
RESET
MONTR
HR
CNT
DM
[Address]
Partial
Clear
Retained if
pressed
All Clear
*Modes in which the given instruction is applicable: R = RUN, M = MONITOR, P = PROGRAM