Honeywell WT6500 Video Games User Manual


  Open as PDF
of 46
 
11
SMARTBOX Installation
SMARTBOX™ Controller for HONEYWELL™ Wind Turbine WT6500 Owner’s Manual - Rev14
Grounding
The SMARTBOX™ Controller is designed to work only with the HONEYWELL™
Wind Turbine. The turbine uses a negative-grounded electrical system. Grounding for
the turbine, battery and AC circuits are provided inside the wiring compartment. Each
ground connection can accommodate up to #6 AWG wire size.
GFI: A fuse rated at .5A 250V, accessible from the bottom of the wiring compartment,
grounds the negative conductor of the turbine and provides turbine ground-fault
protection. Only a Littelfuse 0312.500HXP or equivalent fuse should be used as a
replacement.
SHOCK HAZARD
DO NOT connect the battery negative to ground. NEC
requirements specify that the battery negative ground must
be done only through the 1A fuse. Bonding the battery
negative to ground will disable the turbine’s ground fault
protection and will result in improper operation. The battery
compartment should be grounded if made of metal. Failure
to follow this warning may result in death, personal injury or
property damage.
SHOCK HAZARD AND FIRE HAZARD
Fusesmustonlybereplacedbyqualiedservicepersonnel,
suchasacertiedelectricianortechnician.Forcontinued
protectionagainriskofre,replaceonlywiththesametype
and rating of fuse. Failure to follow this warning may result
in death, personal injury or property damage.
SHOCK HAZARD
Disconnect wind and battery circuits before removing the
grounding connections or before removing or installing
the fuse. Wait at least 5 minutes for the internal circuitry to
discharge before servicing the unit. Failure to follow this
warning may result in death, personal injury or property
damage.
Wiring
PROFESSIONAL INSTALLATION: REQUIRED
Installations must meet all local electrical codes. Installations for the equipment should
onlybeperformedbyaqualiedelectricianoranAuthorizedInstaller.
SHOCK HAZARD
Disconnect turbine and battery circuits before wiring.
Turn off all power before wiring. Failure to follow
this warning may result in death, personal injury or
property damage.
 previous next