Filter
Top Products
15
SECTION V
SERVICING
INTRODUCTION
ALL electrical and mechanical service or repairs should be made with the electrical power to the dryer
disconnected (power off).
WARNING: PERSONAL INJURY COULD RESULT.
The information provided in this section should not be misconstrued as a device for use by an untrained person
making repairs. Service work should be performed by competent technicians in accordance with local, state,
and federal codes. When contacting the factory for assistance, always have the dryer model and serial numbers
available.
CAUTION: Observe ALL safety precautions displayed on the dryer or specified in this manual before
and while making repairs.
Before considering replacement, make sure that ALL connectors are in place and making proper contact.
A. COMPUTER CONTROLS
To Replace Computer Control Panel
1. Discontinue electrical power to the dryer.
2. Disconnect main power harness from rear of
computer by squeezing locking tabs and pulling
connector straight back.
3. Disconnect the “green” ground wire from the
computer.
4. To remove control panel assembly from control box, gently tap the bottom of the control panel upward and lift
off the hinges.
5. Install new control panel assembly by reversing this procedure.
6. When replacing the computer, the “A” and “B” factors must be reprogrammed. (refer to Phase 6 OPL
User’s Manual [ADC Part No. 113022].)
NOTE: The “A” and “B” factors are printed on a label located on the rear of the control panel. (refer
to illustration above.)
7. Reestablish electrical power to the dryer.