Tascam MMP-16 Owner’s Manual • Appendix D • Cable Information
SYNC (MMR-Bus) Connector pinout
PIN # Signal Description PIN # Signal Description
1 CAN_BUS+ 9 CAN_BUS-
2 CCLK_BUS0+ 10 CCLK_BUS0-
3 CCLK_BUS1+ 11 CCLK_BUS1-
4 CCLK_BUS2+ 12 CCLK_BUS2-
5 CCLK_BUS3+ 13 CCLK_BUS3-
6 +12 TERM PWR 14 Frame ground
7 CAN LEFT TERM 15 CAN RIGHT TERM
8 N/C
NOTES:
1. 15-pin D-subminiature female connector (DB-15). The two connectors are
paralleled in the MMP-16 and either can be used as an input or output.
2. Tascam supplies a 3 foot interface cable, 70447. The differential signals should
be routed on twisted pairs of wires.
TIMECODE IN Connector
PIN # Signal Description
TIP Time Code Reader +
Ring Time Code Reader -
Sleeve Ground
NOTES:
1. 1/4” TRS Phonejack
2. 10K Ohm input impedance. Differential input.
TIMECODE OUT Connector
PIN # Signal Description
TIP Time Code Reader +
Ring Time Code Reader -
Sleeve Ground
NOTES:
1. 1/4” TRS Phonejack
2. Differential op-amp output circuit.
