Printing
Problem
Solution
Printed characters are
not what you expect
(continued).
The printer prints
graphic characters or
lines instead
of
the
italic characters you
selected.
The wrong
inkmational
characters are printed.
P&ted
characters are
smaller than you
expect.
The wrong character table is selected. If
your application program can send control
codes, specify the italic character table
using
ESC
t
0.
See page
9-34.
You can also set a DIP switch to select the
italic character table. To do this, turn off
the printer, turn off DIP switch l-3, and
then turn on the printer.
See
page
3-49.
The wrong international character set is
selected. If your application program can
send control codes, specify the desired
international character set using
ESC
R
n.
See page
9-34.
You can also set a DIP switch to select an
international character set. To do this, turn
off the printer, set DIP switches
1-6,
1-7,
and
l-8
to select the character set you
want, and then turn on the printer.
see page
3-47.
Condensed mode may be selected. If your
application program can send control
codes, cancel condensed mode using
DC2.
See page
9-26.
7-8
Troubleshooting
