TToo llooaadd eennvveellooppeess::
1. Open the front cover and set the paper thickness lever to the envelope
mark. Close the cover.
2. Slide the paper feed guide to the left.
3. Press down on the corners
and sides of the envelopes
to make them as flat as
possible by expelling all of
the air.
To avoid paper jams, make
sure envelopes are flat
before you load them into
the paper tray.
Make sure that none of the flaps overlap. If the envelope
edges are not flat, crease them with the side of a pen.
Do not allow more than 10 envelopes to stack on the paper
output tray.
4. With the address side
facing up and pointed in
the direction shown in the
illustration, align the stack
with the right side of the
paper rest, then insert the
stack into the printer.
5. Slide the paper guide to the
edge of the envelopes until
it is firmly in place.
When printing envelopes, be sure to select
EEnnvveellooppee
as the
Media Type on the Main tab of the Properties window. For
more information, see page 9 (Windows) or page 10 (Mac OS)
of this guide, or refer to the S300 User’s Guide on the Setup
Software & User’s Guide CD-ROM.
Basic Printing
66
Flap side of envelope faces down
S300 Chapter 01.qxd 5/12/01 1:44 PM Page 6
