23
| P a g e © Adam Equipment Company 2011
7.0 USER
PARAMETERS
Pressing the [Func/C] key during normal operation allows the user to access
the parameters for customizing the scale. The parameters are split into 4
groups-
1. Check weighing parameters,
2. Percent and Animal Weighing Functions
3. RS-232 parameters and
4. Scale parameters
• When [Func/C] is pressed, display will first show “FunC 1” for Check
weighing parameters.
• Press either the [Func/C] key or the [Pcs/] to advance through the
groups “FunC 1”, “FunC 2” , “FunC 3” and “FunC 4”. Press [Z/T] to enter the
desired group of parameters.
• When in one of the sections press [Print/M+/Esc] to return to the group
“FunC 1”. If you press [Print/M+/Esc] again, the scale will exit the User
Parameter section and return to normal weighing.
7.1 CHECK
WEIGHING
PARAMETERS
• Press [Z/T] to enter the group.
• Use the [Unit/] key and [Pcs/] key to set the values or just the
[Pcs/] key to select the options.
• Press [Z/T] to confirm the change and then advance to the next
parameter by pressing the [Pcs/] key.
This group of parameters-
- Set low and high limits for check-weighing
- Enables or disables the check weighing alarm
- Enables or disables the negative check weighing
