20
| P a g e © Adam Equipment Company 2011
comparison to the capacity of the system. A smaller weight will show
only “100%” while a larger weight might show “100.00%”.
• If the scale was showing zero weight when entering this function, then
the user must manually enter the weight to be set as 100% as
described below.
• Press the [Z/T] key. “P1 PCt” will be displayed.
• Press [Z/T] again to enter percent weighing. The scale will now accept
a value the user enters as the reference weight.
• Enter the value using the [Unit/] key and [Pcs/] key to set the
values of the 100% mass.
• When set press the [Z/T] key to store the value. The display will show
“0.00 %”.
• The weight entered must be greater than 50 scale divisions.
• Press [Unit/] to return to weighing.
NOTE:
The display may jump by large numbers unexpectedly if small weights are
used to set as 100% reference. The scale checks if the weight is too small
and will show Error 7.
