44
| Page © Adam Equipment Company 2009
10.1.1 SERIAL INTERFACE PARAMETERS
The parameters affecting the serial setup are set in a similar manner to the
other parameters.
Press [Setup/Enter] when “SERIAL” is displayed to enter the sub-menu.
The parameters that can be set are shown below, default values are in bold:
BAUD RATE
Set the Baud Rate to 2400, 4800, 9600, 19200 or
38400
PARITY
Set the Parity to OFF, EVEN or ODD
CONTINUOUS To output the weight only at the interval time set in the
INTERVAL parameter. Overrides the printing of any
test results. Option is ON or OFF.
INTERVAL Sets the time in seconds between output of weight
values, if CONTINUOUS output is turned on.
These parameters apply to both the RS-232 and the USB Serial Interfaces.
The interfaces operate in parallel so they both output the same data at the
same time. It is up to the user to beware to prevent possible conflicts if both
interfaces could receive data at the same time.
