Filter
Top Products
17
47” ESPRESSO GAMING TV STAND
www.insigniaproducts.com
Step 11: Install the back
1 Carefully turn your TV stand over onto its front edges. Unfold the back (I) and lay it over your TV stand.
2 Make equal margins along all four edges of the back (I). Push on opposite corners of your TV stand if needed to
make it “square.”
3 Fasten the back (I) to your TV stand using the 48 nails (PP).
Note: Make sure that you tap nails into the holes that line up over the uprights and shelf.
Note: Perforations have been provided for access through the back. Carefully cut out the holes needed.
PP
Do not stand your TV stand upright
without the back attached. Your stand
might collapse.
These holes must line up
over the uprights and shelf.
You’ll need:
PP (48) Hammer
NT-13SGAM_14-0248_MAN_V1_ENG.fm Page 17 Thursday, May 1, 2014 11:22 AM