Filter
Top Products
Getting Started Connections Playback Specifications
Memo Function Utility
1
u During seamless looping, press the A/B TRIM
button to turn on the adjustment mode.
b During playback in modes other than looping, the
next file mode is set when the A/B TRIM button is
pressed.
2
i Press the
A1
or
A2
buttons to select the A point.
b Adjustment is possible for the currently playing
loop.
b Press the B button to select the B point.
3
Turn the Scratch disc to adjust the A or B
point.
The position can be adjusted in units of
frames.
A Point:
±30 frames from the A point. If there is a B
point, however, adjustment is only possible up
to 5 frames before the B point.
B Point:
Adjustment is possible from 5 frames after the A point through
the end of the track.
4
Press the A1 button to set the A point.
When set, the A/B TRIM mode is exited
automatically.
A/B Trim
The positions of the seamless loop A and B points can be
fine-adjusted with the Scratch disc.
The points can be fine-adjusted while listening to the loop
play sound.
Auto BPM Counter
The BPM for the currently playing track or the track at which
the cue standby mode is set is measured automatically and
displayed.
• When the auto BPM counter is off, press the TAP button for
over 1 second to turn the auto BPM counter on.
• When the auto BPM counter is off, it turns on when the track
changes.
NOTE
It may not be possible to automatically measure the BPM accurately
for some tracks.
In this case, perform the “TAPPING” or “MANUAL INPUT”
procedure.
1
BPM LOCK
The data measured with the auto BPM function is
locked.
o When the auto BPM counter is on,
press the
TAP
button and release it
immediately.
“BPM LOCK” is displayed for about 1 second.
2
TAPPING
The BPM is measured according to the
interval between repeated pressings of
the TAP button.
When the TAP button is pressed, the auto BPM counter turns
off.
The “Manual iIn” is displayed.
Q0 Press the
TAP
button repeatedly 5 ~ 10 times to the
beat of the music.
3
MANUAL INPUT
Q1 Press and hold in the
TAP
button for
over 2 seconds.
The BPM can now be input manually.
Q2 Turn the
PARAMETERS
knob and input the BPM
value.
b Turn the PARAMETERS knob while pressing it to input
values below the decimal point.
b When the TAP button is pressed again, the value you
have input is set and the BPM value is locked.
NOTE
If the MP3 or WAV file includes BPM information in the memo data,
this value is displayed as the initial value. The AUTO/TAP/MANUAL
value can be ignored as this information is more detailed.
Basic Operations