71
Printer Configuration and Adjustment
Adjust Printer Settings
4/8/14 ZT400 Series™ User Guide P1066582-002
Calibration and Diagnostic Tools
Table 2 • Calibration and Diagnostic Tools
Print
Information
Print the specified information on one or more labels.
Accepted values:
• SETTINGS—prints the printer configuration
label.
• NETWORK—prints the settings for any print
server that is installed.
• FORMATS—prints the available formats stored
in the printer’s RAM, Flash memory, or optional
memory card.
• IMAGES—prints the available images stored in
the printer’s RAM, Flash memory, or optional
memory card.
• FONTS—prints the available fonts in the printer,
including standard printer fonts plus any optional
fonts. Fonts may be stored in RAM or Flash
memory.
• BARCODES—prints the available bar codes in
the printer. Bar codes may be stored in RAM or
Flash memory.
• ALL—prints the previous six labels.
• SENSOR PROFILE—shows the sensor settings
compared to actual sensor readings. To interpret
the results of the sensor profile, see Sensor Profile
on page 170.
Related ZPL command(s):
Settings:
~WC
Network: ~WL
Sensor profile: ~JG
Others: ^WD
SGD command used: none
User menu item:
Settings: PRINT INFORMATION on page 97
Network: PRINT INFORMATION on page 106
Sensor profile: PRINT INFORMATION on page 113
Control panel key(s):
Settings and Network: Do one of the following:
• Hold CANCEL during printer power-up.
• Hold FEED + CANCEL for 2 seconds when
the printer is in the Ready state.
Sensor profile: Hold
FEED + CANCEL during printer
power-up.
Printer web page: View and Modify Printer Settings >
Print Listings on Label
