A SERVICE OF

logo

Open as PDF
next previous
Printer Setup and Operation
Load the Media—Cutter Mode
58
P1066582-002 ZT400 Series™ User Guide 4/8/14
2. Slide in the outer media guide until it just touches the edge of the media.
3. Rotate the printhead-open lever (1) downward until it locks the printhead in place.
4. Does the media that you are using require ribbon for printing? If you are not sure, see
When to Use Ribbon on page 18.
If using… Then…
Direct Thermal media (no ribbon needed) Continue with step 5.
Thermal Transfer media (ribbon needed)
a. If you have not already done so,
load ribbon in the printer. See
Load the Ribbon on page 60.
b. Continue with step 5.
1