A SERVICE OF

logo

Open as PDF
next previous
Printer Configuration and Adjustment
Adjust Printer Settings
68
P1066582-002 ZT400 Series™ User Guide 4/8/14
Print Method Specify if the printer is to use Direct Thermal mode (no ribbon) or Thermal Transfer mode
(using thermal transfer media and ribbon).
Accepted values:
• THERMAL TRANS
• DIRECT THERMAL
Related ZPL command(s):
^MT
SGD command used:
ezpl.print_method
User menu item: PRINT METHOD on page 94
Printer web page: View and Modify Printer Settings > Media Setup > Print
Method
Tear-Off
Position
If necessary, adjust the position of the media over the tear-off bar after printing.
• Higher numbers move the media out (the tear line moves closer to the leading edge of
the next label).
• Lower numbers move the media in (the tear line moves closer to the edge of the label
just printed).
Accepted values:
–120 to 120
Related ZPL command(s):
~TA
SGD command used:
ezpl.tear_off
User menu item: TEAR OFF on page 95
Printer web page: View and Modify Printer Settings > General Setup >
Tear Off
Table 1 • Print Settings (Continued)
1
2
1
Media direction
2
Factory-set tear line location at position 000