Command Line Interface
A-14
6371-A2-GB20-10August 2000
show ip route [ip-address ]
If an IP address is not provided, the entire table will be displayed with the upstream
routes displayed first and the downstream routes next. If the IP address is provided, only
the specific entry will be displayed. If the next hop IP address = 0.0.0.0, the host is
directly reachable on the Ethernet interface (eth1).
Minimum access level: Operator
Sample show ip route display:
source ip-addr
source subnet-mask nexthop ip-addr interface
x.x.x.x x.x.x.x x.x.x.x dsl1
dest ip-addr
dest subnet-mask nexthop ip-addr interface
x.x.x.x x.x.x.x x.x.x.x eth1
show arp
Sample show arp display:
ip-addr
MAC addr timeout (min) status
x.x.x.x xx:xx:xx:xx:xx:xx xxxx xxxx
NOTES: – The timeout value shown is the actual time left for the specific entry.
– The timeout value shown will be Static for configured static entries.
– Status is Complete or Incomplete.
show arp timeout
ARP – timeout for complete = 20 min.
timeout for incomplete = 5 sec.
show nat basic
Sample show nat basic display:
NAT basic – { disabled | enabled }
NAT basic – public network address: xxx.xxx.xxx.xxx
NAT basic – public network mask: xxx.xxx.xxx.xxx
NAT timeout: xx minutes
NAT basic mappings:
public ip
private-ip
x.x.x.x x.x.x.x
