20
Chapter 1: The basics
When you have finished installing the option card(s):
1 Fit the metal shield into the slots and reattach
the screws.
2 Put the printer back to its original upright
position.
3 Re-install the print cartridge.
4 Reconnect the computer cable and latch the
metal clips.
5 Plug the power cord into the printer.
6 Turn the printer on.
As the printer powers up and the operator panel
lights begin cycling on and off, there is a pause
while the new memory is tested, then the lights
continue cycling.
7 When the Ready light comes on, press the
operator panel button briefly and print a test
page to verify that printer memory or additional
flash memory is installed.
If the Ready light does not come on, see Printing
problems
.
