6
Chapter 1: The basics
12 When you finish, exit the setup program and
remove the CD from your computer.
If you are using Windows 98:
1 Make sure your computer and printer are turned
off.
2 Connect the USB cable to the port on the back of
your computer.
3 Connect the other end of the cable to the USB
port on the back of your printer.
4 Turn on your computer and your printer.
5 When the Add New Hardware Wizard screen
appears:
a Select Next to begin searching for the new
drivers.
b Select Next to use search for the correct driver.
c Make sure the Floppy disk drives, CD-ROM
drive and Microsoft Windows Update check
boxes are cleared, and select the
Specify a
location
check box.
d Insert the Drivers, MarkVision, and Utilities CD
that came with your printer and select B
rowse.
e Double-click the letter of your CD drive, then
double-click the Win98USB folder beneath it.
f Highlight the language you wish to install
USB support for, then click
OK.
g Select Next.
h Select Next again.
i When the hardware is loaded, click Finish.
The printer driver installation program
automatically launches after a few moments.
LA.bk Page 6 Thursday, February 8, 2001 2:19 PM
