A SERVICE OF

logo

Step 3
-
Check the Keyspan Serial Assistant
Now that your serial device is connected to the Keyspan adapter, you should check to see if the
Keyspan serial port is installed correctly.
To do this, open the
Keyspan Serial Assistant
(located in Control Panels). When you open the
Keyspan Serial Assistant
, you will see the following window:
the
Keyspan Serial Assistant
window
If your Keyspan hardware and software are installed correctly, the '
Serial Adapter Status
' text
box will report 'Driver and UPSH-112 Device found OK' or '...Renumerating...Done'.
If you see either of these messages, proceed to
Step 4
. If you do not receive either of these
messages, proceed
Problem Solving
section in this manual.
Step 4
-
Determine Where To Select/Configure The Keyspan Serial Port(s)
Prior to using your serial device with a Keyspan serial port, you must first tell that serial device's
software
which serial port your serial device
hardware
is connected to.
(continued on next page...)
Keyspan:Mini Port Replicator for Mac OS-v2.6 User Manual
This User Manual applies to the Keyspan Mini Port Replicator Software for
Mac OS
.
(rev 02jun20JA)
Page 8