A SERVICE OF

logo

Open as PDF
next previous
The Assist Menu
the
Assist
menu
The Keyspan Serial Assistant's
Assist
menu
is located in the Menu bar and provides access to the
following
command(s):
• The Loopback Test
command performs an 'internal loopback test.' This tests the ability of
the Adapter to
send
data. Since this test
does not test the ability to receive data
.
Results of this test listed in the
Serial Adapter Status
text box.
Please note that this test
cannot take place when the Keyspan serial port is in use by another application.
Note: The Loopback Test is not available on the Keyspan Mini Port
Replicator.
• The
Advanced Settings
button will access the Keyspan adapter's advance configuration
options. Once you click this button, you will open the
Keyspan Manager
window.
• The External Loopback
command tests the Adapter's ability to
send and receive data.
This test requires an external 'loopback connector'. For details about external loop back
connectors, please read the
External Loopback Connector
information in
Serial Port Pin Outs
appendix in this manual.
5.1.a - Keyspan Manager
The Keyspan Manager
window allows you to modify characteristics of your Keyspan serial
port(s). You should only change settings in this window if you are sure that you specifically need
to change them.
To open the
Keyspan Manager
, click the "Advanced Settings" button in the
Keyspan Serial Assistant
control panel (located in your
Control Panels
folder (located in your
hard drive's
System Folder
)). This will open the
Keyspan Manager
window.
(continued on next page...)
Keyspan:Mini Port Replicator for Mac OS-v2.6 User Manual
This User Manual applies to the Keyspan Mini Port Replicator Software for
Mac OS
.
(rev 02jun20JA)
Page 12