A SERVICE OF

logo

Installing the Keyspan Mini Port Replicator Hardware
The following hardware installation instructions provide a basic overview on installing the
Keyspan
Mini Port Replicator
in a USB port. For detailed instructions on how to connect USB devices
your specific computer, please refer to the USB Device Install section in your computer's user's
manual.
Step 4
- Connect the USB cable to the Adapter (if necessary)
If your Keyspan adapter does not have an attached USB cable, attach the included USB cable into
the Keyspan adapter's USB port.
Step 5
-
Connect the Adapter to your USB port
Attach the Adapter to your computer by connecting the Adapter's USB cable into any built-in USB
port on your computer or USB Hub. It is not necessary to turn off your computer when attaching
the Adapter.
Step 6
- Hardware Installation Complete!
Your Keyspan Mini Port Replicator is ready for use now that you have installed hardware and
software.
Please proceed to the
Configuring Your Serial Device
section in this manual for instructions on
what to do next.
Keyspan:Mini Port Replicator for Mac OS-v2.6 User Manual
This User Manual applies to the Keyspan Mini Port Replicator Software for
Mac OS
.
(rev 02jun20JA)
Page 6