Using SelecTType
The display shows one of the choices in the INPUT option to the
right. Most options have further levels, called submenus, or a list
of choices connected to the option. Some options, like the SUB
CONFIG option, may display only the main option until you enter
the submenu. And some options, like the VERSION option, simply
display information about your printer.
You use the button to enter the next level of an option.
Press to enter the next level of the INPUT option.
indicates that STD is selected, and in some cases a message (SET,
EXEC, or PRINT) appears to the right of the option shown.
In the INPUT option, you can display any of the choices listed
below.
STD
OPT
AUTO
OPT appears only when you install the optional lower paper
cassette.
Press or to move to AUTO. Your display should look
like this:
indicates that the option is not selected and SET indicates that
you can set that option by pressing
SelecType 3-9
