LQ and FX Emulation Modes
ESC U
Select print direction
ESC s
Set/cancel half-speed printing
ESC r
Select color printing
ESC i
Incremental view
ESC +
Select n/360-inch line spacing
The following commands are available in FX mode but not in LQ
mode:
ESC
1
7/72-inch line feed
ESC ˆ
Select 9-pin graphics mode
ESC I
Select character code table
The printer commands listed below function in a slightly different
way when used in LQ or FX emulation mode. Also, many of the
commands that control the print position use approximations
because of the difference in print density from LQ/FX series
printers.
ESC G / ESC E
These commands produce identical bolding effects on the EPL-7000
printer. On an actual LQ series printer, these two commands create
slightly different effects and can be combined to produce darker
characters.
SI / ESC SI
These commands print
10
cpi characters in a
16.66
cpi font, and
12
cpi characters in a 20 cpi font. On an actual LQ/FX series printer,
these command condense the font.
ESC x
This command is normally used to select between draft and LQ
quality with an LQ or FX series printer. However, this command
has no effect on EPL-7000 print quality since all characters are
printed at 300 dpi. (dots per inch) Letter Quality.
C-12
Appendix C
