© Adam Equipment Company 2009
6
4.0 SET UP
4.1 ASSEMBLING
OF
SCALE
•
Put the scale on a stable and even table.
•
Adjust the height of the feet to level the scale; the spirit level bubble
should be in the center of the spirit level.
•
Put the pan support in place, inserting the pan support pins into the
holes on top of the scale. Place the stainless steel pan on the support.
•
Don’t press the scale with great force or the load cell could be
damaged.
4.2 ASSEMBLING
OF
BATTERY
AND
POWER
In some cases the rechargeable battery must be shipped separate from the
scale. In this case the user must install the battery.
Remove the battery cover under the scale and put the 6v 4Ah rechargeable
battery provided in to the battery compartment. Connect the battery to the
cable paying attention to the polarity. The red connector goes to the (+)
positive terminal on the battery, the black connector goes to the (-) negative
terminal on the battery.
The adapter provided with the scale is used to charge the battery. Make
certain the adapter matches the voltage of the location you are using the
scale in.
