© Adam Equipment Company 2009
9
•
The display will show “100.0%”.
•
When another item with a different weight value is put on the pan, the
relative % value would be shown against the initial reference sample
value.
•
Press the [Zero/
ESC
] key to exit and go back to weighing mode.
5.3.3 CHECK WEIGHING
•
When in normal mode, press [Func/
] three times to move to the
check weighing mode.
•
The display will show “CHECK”.
•
Press [Tare/
↵
↵↵
↵
] to set the high limits. The display will show the “000000
HI” with one digit flashing.
•
Press [Hold/
] to increase the flashing digits;
•
Press [Units/
] to decrease the flashing digits;
•
Press [Func/
] to select the digit;
•
Press [Tare/
↵
↵↵
↵
] to accept the value and move to set the low limits. The
display will show “000000 Lo”
•
Use the same method the set the low limits and press [Tare/
↵
↵↵
↵
] two
times to start the check weighing.
•
Put the item on the pan, if the weight is below the low limits, the scale
will show “xxxxx.x Lo”; if it is higher than high limits, the scale will
show“xxxxx.x HI”. Otherwise the scale will show “xxxxx.x OK”。
•
Press the [Tare/
↵
↵↵
↵
] key to exit and go back to weighing mode.
5.3.4 HOLD FUNCTION
•
When in weighing mode, press [Func/
] four times until the display
shows“5 HOD”
•
Press the [Hold/
] key to go through the holding time of 5、10、20、
30 and AUTO.
