© Adam Equipment Company 2009
12
6.4
HOLD
FUNCTION
MODE
•
Press [Hold/
] to change the state of the function.
•
" OFF HOD "：Hold function is off all the time and not available to the
user to set as in section 5.3.4.
•
“ ON HOD”: Hold function is enabled.
•
Press [Tare/
↵
↵↵
↵
] to confirm and move to the next setting. When you
enter parts counting function, it will show "On PCS " or "OFF PCS ".
6.5
PARTS
COUNTING
FUNCTION
•
Press [Hold/
] to switch on or off the part counting function.
•
"OFF PCS" :part counting function is off.
•
"ON PCS" : part counting function is enabled.
•
Press the [Tare/
↵
↵↵
↵
] key to confirm the setting and move to the next
setting. It would enter the percentage weighing when it shows "On
PEr " or "OFF PEr".
6.6
PERCENTAGE
WEIGHING
FUNCTION
•
Press [Hold/
] key to switch on or off this function.
•
"OFF PEr ": percentage function is off.
•
"ON PEr”: percentage function is enabled.
•
Press the [Tare/
↵
↵↵
↵
] key to confirm the setting and move to the next
setting. It enters the check weighing when it displays "On CHE" or "OFF
CHE".
6.7
CHECK
WEIGHING
FUNCTION
•
Press [Hold/
] to switch on or off this function.
•
" OFF CHE "：check weighing function is off.
•
" ON CHE"：check weighing function is enabled.
•
Press the [Tare/
↵
↵↵
↵
] key to confirm and move to the next setting. It
enters the calibration mode when is shows "On CAL" or "OFF CAL".
