A SERVICE OF

logo

118
Click Port configuration, Ethernet port configuration, Bandwidth control. Users can
configure port bandwidth control. See the equivalent CLI command at 3.2.1.2.1
& Port – Specify the port
& Bandwidth control level – Port bandwidth control; valid ranges is 1
to 10000 in Mbps.
& Control type –input and output means that bandwidth control is
applied to the inbound and outbound traffic; input means that
bandwidth control is only applied to the inbound traffic; output
means that bandwidth control is only applied to the outbound
traffic.
For example: Specify port as Ethernet1/1; set Bandwidth control level to 5000; set
Control type to input, and then click Apply. The configuration is applied on the port 1/1.
The switch port information is shown in post list page:
3.5.2 Vlan interface configuration