VIZIO VP42 HDTV User Manual
Version 9/11/2006 56
www.VIZIOCE.com
4.15.3 Programming for DVD Player
1. Manually turn on the DVD Player.
2. Press the DVD button on the remote control.
3. Press and hold the SETUP button until the LED LIGHT flashes twice.
4. Find the programming code for your DVD player in the code list in the back of this book and enter it
using the Number Buttons. If the code is accepted, the LED flashes twice after the last digit is
entered.
If the LED does not flash twice, repeat Steps 2 through 4 with the next code listed for the component and
manufacturer.
5. Point the remote control at the DVD Player and press the POWER button. The DVD Player will turn
off.
4.15.4 Searching for Component Codes
If you cannot find the manufacturer in the component list or the program code does not work, you can use
the remote control to search for the correct component code.
To search for a component code:
1. Turn on the component.
2. Press the matching component button on the remote control.
3. Press and hold the SETUP button until the LED flashes twice.
4. Press 9 9 1. The LED flashes twice.
5. Point the remote control at the component and then alternate between pressing the POWER
button and the component button on the remote control until the component turns off.
If the component still does not respond, clear the component button, then repeat the search
procedure.
4.16 Using a Cable or Satellite Remote
Your VIZIO remote uses codes 11758 and 10178 to work your Plasma HDTV. To use a cable or satellite
remote to work the Plasma HDTV, refer to your cable or satellite remote user guide for more information
on how to program the remote. If your cable or satellite remote uses a 5-digit code (like most Direct TV
units), first try 11758 and then, if that does not work, 10178. If your cable or satellite remote uses a 4-
digit code, try 1758 and then 0178 as an alternative. If your cable or satellite remote uses a 3-digit code
(Echostar or Dish Network for example), use code 627.
Note: Some buttons may not function as expected on your cable or satellite remote. Typically power,
volume and mute will work.
Note:
a) If your DVD player does not respond, try all the codes for your brand. If the codes do not
work, or your brand is not listed, see “Searching for Component Codes.”
b) Sometimes a code listed will only include limited functions. Try other codes that may
include more functionality.