5
US
– Never place the console in a confined space, such as a bookcase,
or built-in cabinet, unless proper ventilation is provided.
– Do not place the console near or over a radiator or heat register,
or where it is exposed to direct sunlight.
ANTENNAS
Outdoor Antenna Grounding
–
If an outdoor antenna or
cable system is installed, follow the precautions below.
An outdoor antenna system should not be located in the
vicinity of overhead power lines or other electric light or
power circuits, or where it can come in contact with
such power lines or circuits.
WHEN INSTALLING AN OUTDOOR ANTENNA
SYSTEM, EXTREME CARE SHOULD BE TAKEN TO
KEEP FROM CONTACTING SUCH POWER LINES
OR CIRCUITS AS CONTACT WITH THEM IS
ALMOST INVARIABLY FATAL.
Be sure the antenna system is grounded so as to provide
some protection against voltage surges and built-up
static charges. Section 810 of the National Electrical
Code provides information with respect to proper
grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna discharge
unit, size of grounding conductors, location of antenna-
discharge unit, connection to grounding electrodes, and
requirements for the grounding electrode.
Lightning
For added protection for this console during a lightning storm, or
when it is left unattended and unused for long periods of time,
unplug it from the wall outlet and disconnect the antenna or cable
system. This will prevent damage to the console due to lightning
and power-line surges.
SERVICE
Damage Requiring Service
Unplug the console from the wall outlet and refer servicing to
qualified service personnel under the following conditions:
– When the AC power cord or plug is damaged or frayed.
– If liquid has been spilled or objects have fallen onto the console.
– If the console has been exposed to rain or water.
– If the unit has been subject to excessive physical shock by being
dropped, or the console exterior has been damaged.
– If the console does not operate normally when following the
instruction manual. Adjust only those controls that are specified
in the instruction manual. Improper adjustment of other
controls may result in damage and will often require extensive
work by a qualified technician to restore the console to normal
operation.
– When the console exhibits a distinct change in performance
–
this indicates a need for service.
Servicing
Do not attempt to service the console yourself, as removing the
console exterior may expose you to dangerous voltage or other
hazards.
Refer all servicing to an authorized service center. Call 1-800-345-
7669 to receive instructions on obtaining repair/replacement
services.
Replacement parts
When replacement parts are required, be sure the service
technician has used replacement parts specified by the
manufacturer that have the same characteristics as the original
parts.
Unauthorized substitutions may result in fire, electric shock, or
other hazards.
Safety Check
Upon completion of any service or repairs to the console, ask the
service technician to perform routine safety checks (as specified
by the manufacturer) to determine that the unit is in safe
operating condition.
Antenna Lead
in Wire
Ground Clamp
Antenna
Discharge unit
(NEC Section
810-20)
Electric
Service
equipment
Ground Clamps
Power Service Grounding
Electrode System
(NEC Art 250, Part H)
Grounding Conductors
(NEC Section 810-21)
FRAYED OR TAUT AC power cord
Getting started
CRACKED PLUG
NEC- National Electrical Code