Filter
Top Products
Using the RS 220
16 | RS 220
Using the RS 220
To switch the product on and to listen to your audio source, proceed as
follows:
Switching the transmitter on/off
Switching the transmitter on
̈ Touch the Power touch key F.
The transmitter switches on. The LED of the last selected audio source
(here COAXIAL) lights up. The ON LED G flashes until the transmitter
has found suitable headphones and then lights up continuously.
Sequence of steps Page
1. Make sure that the rechargeable batteries are charged. 14
2. Switch your audio source on. –
3. Switch your transmitter on. 16
4. Switch your headphones on. 19
5. Select the desired audio source. 21
6. Put on the headphones. 15
7. Adjust the desired volume on the headphones. 23
If the transmitter doesn’t receive an audio signal for more than
3 minutes, it switches, depending on the setting, to either standby
mode or loop through mode. If the transmitter receives an audio
signal within the next 10 minutes, it automatically switches on
again.
ON
F
G