Filter
Top Products
26
Rosen A10 Owner’s Manual
WHY DO I GET NO RESPONSE WHEN I PRESS THE REMOTE
BUTTONS?
Check the battery in the remote control.
THE DOME LIGHT WENT OUT - WHY?
The dome light has a 5-minute timer to prevent accidental battery drain.
I HAVE BLACK BARS ON THE TOP AND BOTTOM OF MY SCREEN
WITH A WIDESCREEN DVD - HOW DO I GET RID OF THEM?
See page 20.
WITH THE AC3072 DUAL-CHANNEL HEADPHONES, CHANNEL A
AND CHANNEL B HAVE THE SAME AUDIO. HOW DO I CHANGE
WHAT I HEAR ON CHANNEL B?
Press OUTPUT B and then press SOURCE to change Output B’s
assigned source. See page 22 for more information on dual-zone use.
WHY DOESN’T THE STOP/EJECT BUTTON DOESN’T EJECT THE
DISC RIGHT AWAY?
While a disc is playing, this button acts as a STOP button. To eject a
disc while it is playing, press the STOP/EJECT button twice in quick
succession. The Eject button on the remote control always ejects the
disc immediately.
THE DISC WILL NOT EJECT AT ALL - WHAT DO I DO?
Using a paper clip, press the reset button (see page 7 for its location).
If this section does not address your question, please contact your
Rosen authorized dealer. Also, your system has internal diagnostic
capabilities that are accessible to authorized Rosen dealers. To locate
a Rosen Entertainment Systems authorized dealer, please visit
www.rosenentertainment.com.
FAQ’S
I HAVE NO PICTURE AND NO SOUND - WHAT’S WRONG?
The system has low- and high-voltage and temperature protection
circuits. If the voltage or temperature goes beyond the limits, the
system shuts off. The power wire or power harness may have been
disconnected, or the fuse may have failed. Contact your Rosen
authorized dealer to determine if this is the case.
Note: The system voltage range is 11-16VDC operating
voltage. The system operating temperature is 0
o
to 60
o
Celsius. Use of the system beyond the safe operating ranges
listed can cause temporary or permanent damage to the unit -
such damage may not be covered by manufacturer’s warranty.
I HAVE A PICTURE, BUT NO SOUND OR DISTORTED SOUND. WHY?
Check the MUTE button. Check the volume on the radio, and make
sure the radio is tuned to the right frequency - try tuning the FMM and
the radio to a new frequency. Check the headphones; ensure the
headphones have a direct “line of sight” to the infrared transmitter
below the monitor. Replace headphone batteries, if needed. Check
the DVD Setup Menu - the Audio Output setting must be set to
“ANALOG” and the Speaker Downmix setting must be set to
“STEREO”. If using a CD you have made yourself, make sure you did
not set the recording level too high. Make sure you to check CH A and
CH B if you are using AC3072 two-channel headphones.
WHY DON’T THE PREVIOUS OR NEXT BUTTONS WORK WITH A
VCD?
Some VCDs don’t support these - erratic operation can result.