Filter
Top Products
10
Rosen A10 Owner’s Manual
Note: The internal DVD player can be configured for either a
16:9 “Wide” image output or a 4:3 standard image output.
Since the A10 has a widescreen display, the DVD player
should be configured for “Wide”. See page 20 for more
information.
USING THE BUILT-IN DOME LIGHTS
The A10 system has built-in dome lights. In many vehicles, these built-
in dome lights replace an original factory dome light which was
displaced when the system was installed. The dome lights are
controlled by both the Dome Light button on the front panel and by the
matching Dome Light button on the remote control.
When the lights are off, press either button to turn them on.
When the lights are on, press either button to turn them off.
When the lights have been turned on manually using the Dome Light
button, they will automatically turn off after all the doors are closed.
ENTER
OPEN
SOURCE
Note: Some vehicles have a dome light dimming feature that
causes the light to fade out gradually after the doors are
closed. The A10’s dome light may not fade at the exact speed
that the factory dome lights fade, but it will turn on and off
normally when the doors are opened and closed.
CHANGING AND ADJUSTING THE DISPLAY
Selecting a display mode: The system’s “widescreen” display has
a 16:9 aspect ratio - wider than a standard television. While many
DVD’s provide widescreen video images that fit the screen, standard
broadcast TV and many video games don’t.
• To view widescreen DVD’s, press the DISPLAY MODE button
until “WIDE” is displayed on the screen.
• To watch “fullscreen” DVD’s, the internal game system, or
broadcast television, select “STANDARD”.
Display adjustments: The display has adjustable video settings. To
change these settings, press the ENTER button on the overhead
console and hold it for two seconds. The following menu appears:
COLOR 8
BRIGHT 8
TINT 8
SHARPNESS 4
CONTRAST 8
RESET
To select a setting to be changed: Press the DOWN button to move
the cursor down the menu list. After you reach the final setting,
pressing DOWN will cause you to exit the menu. Selecting RESET will
restore the original factory values for all five settings.
To change the value of a setting: Use the LEFT and RIGHT arrow
buttons. The range is from 0 to 15.
Press DOWN to return to the display adjustments menu.
To exit the menu: Press the DOWN button to save settings and exit.
Note: See Page 12 for more on adjusting the Bright setting.
Dome Light
button