Filter
Top Products
Assembling the Treadmill 23
Component Appearance Lower connection
point
Television cable Round with black insulation
Console power
cable
Dual leads with red and
black insulation
Auto Stop sensor
cable
Round with black insulation
Power supply Rectangular, black, 5" x
2¹₄" x 1¹₄"
CAUTION: Be careful not to cut or pinch any wires during the
following step.
3. Place the left-hand upright support into the base frame
side bracket.
4. Secure the left-hand upright support to the side bracket
using four socket head screws, four black washers, and
two locknuts. Partially tighten the fasteners.
Figure 9: Upright support attachment, left side
5. Lower the treadmill fairing assembly over the upright
supports and align it to them.
Important: In the following step, take care not to unseat any
of the components in the stop switch.
6. Feed the upper end of the cable assembly through the
fairing so that its upper end extends through the bottom
opening in the center column and out the round opening
in the console mounting plate.