Filter
Top Products
E-28
● Perform the following steps if a frame is broken and must be replaced.
● If you cannot wear the display unit securely even after increasing or decreasing the space between
the frame arms using the frame adjusters, try switching the left and right frame arms following the
steps below and adjust the space again.
Notes
● To keep the windows of the display unit free of fingerprints, do not touch the windows when changing
the frames.
● Remove the display section from the frame only when necessary (such as when the unit is damaged).
Repeated removal and installation may result in loosening of the frame joints.
Removing the frames
1
Detach the frame adjusters.
1. Remove the headphone from the headphone holder.
2. Slide the frame adjuster to position C in the direction of the headphone. Pull the adjuster out
to detach.
3. Detach the other adjuster following the same procedures.
Frame [Left],
Adjuster [Inside]
Frame [Left],
Adjuster [Outside]
2
Attaching the frames
1. Push the frame into the display unit while matching shapes A (convex) of the frame and B
(concave) of the unit.
2. Place the headphone cord into the frame’s groove.
3. Attach the frame adjuster back to position
C
on the frame.
Left: 1 bump Right: 2 bumps
Remove the frames.
1. Hold the frame so that the window part can be seen.
2. Fold the frame to align A (convex) of the frame with B (concave) of the unit.
3. While keeping A and B in the above position, slide the frame inward horizontally by approx.
1 mm.
4. To remove the right frame, twist it downward, and to remove the left, twist the frame upward.
When pulling the frames out, do not grasp the headphone cable.
Right side frame
Left side frame
CHANGING THE FRAMES
● The frame with 1 bump is attached to the left side, and the frame with 2 bumps is attached to
the right side at the factory, as shown above.