Olympus FMD-250W Video Eyeware User Manual


 
E-15
ENGLISH
Holding the tips of the frame
arms, gently move them apart
to put the display unit on.
Caution:
Do not hold the hinges. Doing so
may disengage the arms.
Remove each headphone upward from the holder as
shown in the figure.
When putting the headphones back in the holders, simply
reverse the order of removal for each.
If you wish to use ear pads on the headphones, use 16.0 mm
ear pads (commercially available).
Wearing the display unit
1
Put the display unit on as if
wearing glasses and insert
the headphones.
Adjust the nose pad to put the
image to the optimal position. If
this adjustment is not performed,
the image may appear dim.
If the image still cannot be seen
properly or is dim after adjusting
the nose pad, switch the left
and right frames (
pg. 28).
When wearing the display unit
over glasses, pull the nose pad
out slightly more than usual.
If you cannot wear the display
unit securely because there is
too much space between the
frame arms, reduce the space
using the frame arm adjusters
(
pg. 16).
2
Be sure to wear the display unit properly so that the image appears clear and stable in both eyes.
If you widen the frame arms too much when wearing the display unit, the frame adjusters may pop
out.
Do not pull or twist the nose pad excessively in directions other than those shown in the figure. This
may break the nose pad or crack its surface.
WEARING/REMOVING THE DISPLAY UNIT
NOTICE
Headphones
Nose pad
Nose pad