Filter
Top Products
Wiring 5-11
DIEGO INTERFACE CONNECTOR AND JUMPER STATUS CHART
DESIGNATION LOCATION FUNCTION MEANING SETTING
DEFAULT
J1 & JP1 UPPER RIGHT VIDEO SIGNALS FROM OPEN
BETWEEN INPUT COMPUTER VIDEO J1 ALL
(NOTE 1) JP2 AND JP16 SIGNALS GRAPHICS CARD JP1 ALL
J2 & J3 LOWER CENTER SERIAL NOT USED IN THIS OPEN
BETWEEN COMM GAME (NO
(NOTE 2) JP7 & JP10 SIGNALS USB COMM)
JP2 UPPER RIGHT VIDEO SIGNALS TO OPEN
BETWEEN OUTPUT GAME VIDEO JP2 ALL
J1 & JP6 SIGNALS MONITOR
JP3 UPPER RIGHT BLUE MATCHES OPEN
BETWEEN VIDEO DRIVE LEVEL 1 & 2
(NOTE 3) JP1 & JP6 LEVEL TO MONITOR 2 & 3
JP4 UPPER RIGHT GREEN MATCHES OPEN
BETWEEN VIDEO DRIVE LEVEL 1 & 2
(NOTE 3) JP1 & JP6 LEVEL TO MONITOR 2 & 3
JP5 UPPER RIGHT RED MATCHES OPEN
BETWEEN VIDEO DRIVE LEVEL 1 & 2
(NOTE 3) JP1 & JP6 LEVEL TO MONITOR 2 & 3
JP6 UPPER RIGHT VIDEO LOCKS VIDEO OPEN
BETWEEN SYNC MONITOR TO 1 & 2
(NOTE 4) L7 & U1 POLARITY SYNC SIGNAL 2 & 3
JP7 LOWER RIGHT PLAYER SIGNALS FROM OPEN
NEAR INPUT SWITCHES AND JP7 ALL
J3 & JP8 SIGNALS STEERING WHEEL
JP8 LOWER RIGHT OPERATOR SIGNALS FROM OPEN
NEAR INPUT CURRENCY AND JP8 ALL
JP7 & S1 SIGNALS TEST SWITCHES
JP9 CENTER LEFT WHEEL STEERING MOTOR OPEN
NEAR DRIVER FEEDBACK AND JP9 ALL
JP11 & U5 SIGNALS LEADER LIGHTS
JP10 LOWER LEFT COIN INDIVIDUAL OPEN
BETWEEN OUTPUT COIN METER JP10 ALL
J2 & P1 SIGNALS DRIVE CIRCUITS
JP11 CENTER LEFT GAME WATCHDOG OPEN
BETWEEN RESET TIMER JP11 ALL
C134 & JP9 SIGNAL CIRCUIT
JP12 CENTER RIGHT BOARD CONNECTOR USED OPEN
NEAR TEST FOR CIRCUIT JP12 ALL
S1 & U8 SIGNALS DEVELOPMENT
JP15 & P1 LOWER RIGHT SERIAL DATA EXCHANGE OPEN
NEAR COMM TO COMPUTER JP15
(NOTE 1) JP10 & U7 SIGNALS CIRCUITS P1
NOTES:
1. Connectors wired in parallel. Use based on type of interconnect cable connector.
2. Alternate forms of communications. Not required for this game.
3. Jumper not required for production video monitors. Install for early production Neotec or other units.
4. Jumper factory set for production video monitors. Change for older positive sync video monitors.