Filter
Top Products
Setup 1-7
INSTALL THE DOOR LOCK AND SECURITY BRACKETS
7. Modify the lock plate at the top of the rear door. Remove the bolts and nuts from the lock plate. Rotate
the plate so that the slot will be above the door. Reinstall the bolts and nuts and tighten firmly.
INSTALL THE POWER CORD
8. The power cord is with the spare parts. Match the holes on the IEC plug with the prongs in the
receptacle. Push the plug firmly to seat it. Route the cord away from cabinet wheels and foot traffic
areas.
9. Refer to the game's Cabinet Wiring Diagram in Chapter 5 and check to see that all cable connectors
are correctly secured. Inspect for damaged connectors. Be sure that you
DO NOT FORCE
CONNECTORS
. Most connectors are keyed to prevent making reversed connections.
CAUTION: CHECK POWER SUPPLY LINE VOLTAGE SELECTOR SWITCH.
Set the
110/220 VAC selector on the power supply for the correct local line voltage. Check the
selector setting before switching on the game.
10. Reinstall the rear door and close it. Lock the rear door and remove the key. If required, install the
extra padlock through the hasp. Install the screws at the top and sides of the rear door. Tighten the
screws snugly. Close and lock the cash box and coin doors.
NOTICE:
Tamper-resistant screws and a matching wrench are provided with this game
for additional security. Four tamper-resistant screws and a wrench are located in the
spare parts bag. If desired, replace the original screws with the tamper-resistant
screws. Tighten the screws firmly with the wrench.
11. Move the game to its play location. Lower each leg leveler until the cabinet is stable and level. Adjust
the levelers as required to raise wheels and distribute weight equally on each corner. Tighten the nuts.
12. Plug the game into a grounded (3-terminal) AC wall outlet. Switch on the game, using the on/off switch
at the top-left rear of the cabinet. The game will power up and begin self-diagnostics. If diagnostics
find no errors, the game enters its Attract Mode of operation.
13. Unlock and open the coin door. Locate the control switches. Press TEST MODE to enter the Menu
System.
14. Follow the on-screen instructions to select the Diagnostics Menu, then choose Hard Drive Tests.
Perform each of the routines to verify hard disk drive operation. If no errors are found, the program
should function well.
15. Return to the Diagnostics screen, then choose Monitor Patterns. Use the various patterns to verify that
the monitor is properly adjusted.