Filter
Top Products
System Administration
SCS160 / SCS320 / SCS480 Page 54 www.thinklogical.com
SCS160R / SCS320R
7.2.1 Run netconfig
After you establish a connection to the SCS using your network, you may want to
change the IP address setting of the SCS to the desired address on your network, using
netconfig.
The netconfig script is a self-prompting program to set up your system’s net-
work information. It supports DHCP/BOOTP setup, or static addressing.
Use the space bar to select / deselect a value (e.g., DHCP). Use the arrow keys
to move up and down between the entry fields.
Note
Use of a static IP address is recommended with the SCS.
You will need the following information before running netconfig:
• Using BOOTP/DHCP (yes/no)? If No, you need the following:
• IP Address
• Net Mask
• Default Gateway
• Primary Nameserver
You can add the secondary and tertiary nameservers (if required) by editing your
resolv.conf file at a later time. After entering the requested information, you are
returned to the root prompt.