Filter
Top Products
083
083
/
CHAPTER 18: PROCESSOR
2
1
3
4
1 processor 3 ZIF socket
2 pin-1 corner of processor 4 ZIF-socket cam screw
Removing the Processor
Follow the instructions in “Before You Begin” on page 1. 6.
Remove the battery pack (see “Removing the Battery Pack” on page 2. 11).
Remove the compartment door (see “Removing the Compartment Door” on 3.
page 14).
Remove the center control cover (see “Removing the Center Control Cover” 4.
on page 33).
Remove the keyboard (see “Removing the Keyboard” on page 5. 38).
Remove the palm rest (see “Removing the Palm Rest” on page 6. 42).
Remove the left and right brackets (see “Removing the Brackets” on 7.
page 47).
Remove the magnesium cover (see “Removing the Magnesium Cover” on 8.
page 50).
Remove the processor heat sink (see “Removing the Processor Heat Sink” on 9.
page 79).
CAUTION: When removing the processor, pull it straight up. Be careful
not to bend the pins on the processor.
To loosen the ZIF socket, use a small at-blade screwdriver and rotate the 10.
ZIF-socket cam screw counterclockwise until it comes to the cam stop.
e ZIF-socket cam screw secures the processor to the system board. Take
note of the arrow on the ZIF-socket cam screw.
Lift the processor o the ZIF socket.11.