Filter
Top Products
6 - Language Dictionary
88
cfRestart
Syntax
int cfRestart(CF_HANDLE server);
Description
This command causes the Agilent MCCD to recall a previously saved restart state. The Agilent
MCCD must be in the CF_IDLE state to perform a restart. The existence of a restart state can be
queried by testing the CF_RESTART bit of the status returned from cfGetInstStatus.
cfSaveOutputConfig
Syntax
int cfSaveOutputConfig(CF_HANDLE server);
Description
This command causes the output configuration setting of each channel to be saved in non-volatile
memory. These settings are set by cfSetOutputConfig.
cfSelftest
CAUTION: Selftest causes voltage to be applied to the outputs. Make sure that no cells are
connected when executing cfSelftest.
Syntax
int cfSelftest(CF_HANDLE server, int *reserved);
Description
This command starts an instrument selftest. This selftest is more thorough than the selftest that is
performed automatically at power-on. The cell supply outputs should be disconnected from any
cells or other loads before the cfSelftest function is called.
This function returns an integer value in the location pointed to by the reserved argument. The
returned value should be ignored, but you must supply a pointer to an integer which will hold the
return value.
Since a selftest can take many seconds to complete, the cfSelftest function does not wait for
selftest to complete but returns immediately after starting selftest. During the selftest, the
CF_SELFTEST_STAT bit is true in the status word returned by cfGetInstStatus. When selftest is
finished, the CF_SELFTEST_STAT bit goes false. If any errors occur during selftest, the
CF_SELFTEST_ERROR_STAT bit is true. Details of the errors can be obtained using
cfReadTestLog. The test log retains this error information until another selftest or calibration
command is given.
See Also
cfReadTestLog, cf GetInstStatus