25
Clean / Clear Water Iron Removal
This feature is beneficial on water supplies containing iron and/or high amounts of sediments (sand,
silt, dirt, etc.). When s et to “ON”, an additional backwash and fast rinse cycle will occur first,
preceeding the normal regeneration sequence. This provides extra cleaning of the resin bed before it
is regenerated with the salt brine. To conserve water set this fe ature “OFF” if your water supply does
not contain iron or sediments.
1. Press and hold the
PROGRAM button until the f ollowing screen is d i splayed.
Once inthis display, press the PROGRAMbutton twice andone ofthe following two displays
is shown. Both displays will show the word “Clean” .
2. Press the
+
Up or
−
Down buttons to set On or Off.
Clean Feature Minutes
Adjust the length of the Clean/Clear Water Iron Removal featur e, from 1 to 15 minutes in length. To
change thiscycle time,use the U Pbuttonto increase thetime, orthe DOWN button t oshorten thetime.
If you are using this feature the length of the extra backwash cycle automatically sets to 3 minutes.
1. Press and hold the
PROGRAM button until the f ollowing screen is d i splayed.
Once inthis display, press the PROGRAMbutton three timesand following display isshown.
2. Press the
+
Up or
−
Down buttons to set number of minutes.
