23
Customizing Features/Options-- Model WHES30
Recharge
Recharge button is used to initiate an immediate recharge.
• Press and hold the
RECHARGE buttonuntilthewords “RECHARGE”,“SERVICE”
and“FILL” flashin thedisplay, and thesoftener entersthe fill cycleof regeneration right
away.The word“RECHARGE” willf lashduring theregeneration.When over, fullwater
conditioning capacity is restored.
RECHARGE NOW Initiated
NOTE: Avoidusinghotwaterwhiletheconditionerisregenerating,because thewater heaterwill
refill with bypass hard water.
Recharge Scheduled
If you do not want to start an immediate recharge, but would like an extra recharge at the n ext preset
recharge time, do the f ollowing to schedule a recharge.
• Press a nd release (do not hold) the
RECHARGE button. The words “RECHARGE
SCHEDULED” flashes inthe display, and the softener will recharge atthe nextrecharge
time. The word “RECHARGE” will flash during the regeneration. When over, full water
conditioning capacity is restored.
SetSaltLevel
The water softener has a salt monitor indicator light to remind you to refill the storage tank with salt.
• To set this monitor system, lift the salt hole cover and level the salt in the storage tank.
The salt level decal, on the brinewell inside the tank, has numbers from 0 to 8. Observe
the number the leveled salt is at, or closest to. Now, press the
SET SALT LEVEL
button until black ovals corespond to the salt level number. At level 2 or below, the
indicator LED will flash “Check Salt Level”.
• If you want to turn the salt monitor off, press the SET SALT LEVEL button until
“SALT LEVEL OFF” shows in display.
