A SERVICE OF

logo

Open as PDF
next previous
SETUP
Contactless Module
20 V
X
810 INSTALLATION GUIDE
5 Slide the tabs on the narrow end of the metal plate down to engage the ears of
the V
x
810.
6 Carefully hold both devices and the metal plate in place. Screw fine-thread
black machine screw into the V
x
810 first. Next, install the 3 coarse-thread self
taping screws into the V
x
810 CTLS module..
Figure 18 Installing the Screws
Figure 19 Installed V
x
810 CTLS Module
WARNING
Be careful. The self taping screws will require a moderate amount of force to
install. Be sure to use the proper size screw driver and to securely support the
V
x
810 CTLS module to avoid any possible damage.
NOTE
You can verify if the module is installed properly through the CONTACTLESS
DIAGNOSTIC function in System Mode of the V
x
810.
For more information, please refer to the V
x
810 Reference Guide, VPN 24964.