SETUP
Contactless Module
V
X
810 INSTALLATION GUIDE 19
Contactless
Module
The V
x
810 supports contactless smart card transactions through the V
x
810 CTLS
module. The SD card slot at the back of the V
x
810 serves as the expansion port
for installing the module as an add-on to the traditional magnetic card reader.
Installing the V
x
810
CTLS Module
To install the V
x
810 CTLS module:
1 Place the device facedown on a soft, clean surface to protect the lens from
scratches.
2 Remove the SD card slot cover and store it in a safe place where it can be
easily retrieved for later use.
3 Slide the connector into the SD card slot of the V
x
810 as illustrated below until
you feel it click into place.
Figure 16 Sliding the V
x
810 CTLS Module Into Place
4 Insert the metal plate onto the back of the module and V
x
810 to hold the
devices in place. To do this, hold the metal plate at an angle as shown in the
figure below, then slide the tabs on the wide end of the metal plate into the
slots of the CTLS module.
Figure 17 Sliding the Metal Plate into Place
NOTE
The SD card cover slot will not be used while the V
x
810 CTLS module is in place.
A B
WARNING
The mechanism that alows you to feel the connector click into place does not
hold the V
x
810 and the V
x
810 CTLS module together.
Once the connector is inserted, hold both devices in place while making sure that
you do not allow the devices to separate so that the connector does not slip
backwards out of the slot.
