A SERVICE OF

logo

Open as PDF
next previous
SETUP
Cable Connections
V
X
810 INSTALLATION GUIDE 15
Connection to
another VeriFone
Terminal
The V
x
810 connects to a VeriFone terminal via a straight cable. There is a
minimum power requirement for the V
x
810, currently specified as 3.5W. In cases
where the terminal is only able to provide a 7 V DC output to power the V
x
810, the
terminal must be able to source at least 0.5 A of current. Otherwise, proper
functioning of the V
x
810 is not guaranteed.
Figure 8 V
x
810 Connected to Another VeriFone Terminal
RS232 Connection
using an External
Power Brick
A special dongle cable is used, where one end of the cable plugs into the V
x
810
while the other end terminates in a DB-9 connector housing. On the housing, a
DC jack is provided to connect to an external power brick. This is a generic cable
for all RS232-based hosts.
Figure 9 V
x
810 with an RS232 Connection Using an External Power
Brick